pull down to refresh
reply
Ok, tnx. I'm doing it for the lightning address receive case, which has always worked up to now (authowithdraw worked as usual 54 minutes ago). But I guess it's because I'm trying to update the settings.
I'll try again next time, hoping things are resolved on alby's side by then.
reply
reply
I managed to update it by using a non-alby Lightning address.
However, when setting zero, it'll actually only withdraw starting from 11 sats, see this screenshot. Is it the same for you? It's kind of an edge case, but might be an important to fully remove custodial service from SN's part. I'll create an issue once you confirm.
autowithdraw
, I keep getting the following error:0
as well as a few non-zero values, to no avail. I can create an issue on github if this is unexpected behavior...