Bottle Holder Design
Specifications:
• Material: 1000D Cordura • Length: 14.5 cm • Base Dimensions: 6.5 cm x 6.5 cm
Components:
1. Main Body: Rectangular piece that wraps around the bottle. 2. Base: Square piece that forms the bottom of the holder. 3. Seams and Hemming: Edges to be sewn together.
Blueprint Outline
Main Body Piece:
• Dimensions: 14.5 cm (height) x 26.0 cm (width) • This width includes 2 cm extra for seam allowance (1 cm on each side) and overlap for stitching.
Base Piece:
• Dimensions: 6.5 cm x 6.5 cm square • Add 1 cm seam allowance around the perimeter, making it 8.5 cm x 8.5 cm total.
Steps to Assemble:
1. Cut the Cordura Fabric: • Cut one rectangle of 14.5 cm x 26.0 cm for the main body. • Cut one square of 8.5 cm x 8.5 cm for the base. 2. Prepare the Edges: • Hem the top edge of the main body piece by folding over 1 cm of fabric and stitching it down. 3. Assemble the Base: • Pin the base piece to the bottom edge of the main body rectangle, right sides together. • Sew along the edges, leaving a 1 cm seam allowance. 4. Form the Cylinder: • Bring the two short sides of the main body rectangle together, right sides facing, and sew them to form a cylinder. 5. Finish the Seams: • Reinforce the seams with additional stitching if needed.
Here is a simple diagram for visualizing the pieces:
Main Body Piece:

| | | | | | | | | | | | |_________________________| |<---- 26.0 cm ---------->|
Base Piece:

| | | | | | | | |________| |<--8.5 cm-->|
What's this? I can tell from the provided measurements that this ain't gonna work out...
reply
I tried. Sorry.
reply