reply on: [bitcoin-dev] Full-RBF Peering Bitcoin Core v26.0 Released \ stacker news ~bitcoin

pull down to refresh

31 sats \ 9 replies \ @OgFOMK 21 Jan \ on: [bitcoin-dev] Full-RBF Peering Bitcoin Core v26.0 Released bitcoin

I'm reading your blogg entry on "Why You Should Run Full-RBF On Your Node" - https://petertodd.org/2023/why-you-should-run-mempoolfullrbf . Looks like my Start9 was not running this. I have enabled it.

I have three on chain transactions on lightning from closes that have never confirmed so maybe I can figure out how to finalize them.

https://m.stacker.news/13168

142 sats \ 1 reply \ @petertodd OP 21 Jan

Thanks!

Unfortunately full-RBF is probably not going to help you with those closes, as it's more likely that they don't meet the minimum relay fee (I assume they're force closes).

The ViaBTC and Binance transaction accelerators could help out. As will the mempool.space one, which is a lot cheaper. But not publicly available yet.

20 sats \ 0 replies \ @OgFOMK 21 Jan

It's one of those things I believe I will eventually figure out but I wont hold my breath. I signed up for the mempool thing and "we'll see."

41 sats \ 6 replies \ @aoeu 21 Jan

I recently enabled this to on my Start9. I also enabled v2 P2P encrypted transport too. It says that it will drop to standard v1 as a fail-safe so can't see any reason not to enable it too, right?

40 sats \ 4 replies \ @Murch 21 Jan

That's right, it'll try v2 first and fall back to v1 when the peer doesn't run v2. I'm running my node with V2P2P as well

30 sats \ 3 replies \ @Murch 21 Jan

There is on-going work to make this behavior the default in the next release in March.

10 sats \ 2 replies \ @petertodd OP 21 Jan

deleted by author

10 sats \ 1 reply \ @Murch 21 Jan

You are working on V2P2P?

In case it was unclear, I meant to convey that the next release will default to running the encrypted v2 p2p message protocol.

10 sats \ 0 replies \ @petertodd OP 21 Jan

Ah, sorry, I misread what you wrote as talking about full-rbf, not V2.

Deleted.

0 sats \ 0 replies \ @OgFOMK 21 Jan

I'm would not know the answer to that question. If you go on telegram Start9 community chat. StartOS support, Your question may get answered there. https://t.me/start9_labs .