pull down to refresh

Problem installing umbrel on Raspberry Pi 4 "couldn't get connection details"
0 sats \ 3 comments \ @GUI 26 Mar 2023 bitcoin
Hey all!
I've setup a new Raspberry Pi 4 box. Everything seems to be ok, flashed my SD card with no issue apparently, connected it to my router via Ethernet and it seems to be working fine.
But when I start Umbrel it get stucks. I have a lot of "OK" lines then I get "couldn't get connection details". It freezes there for 2 mins then I have a last line "[OK] Started daily apt upgrade and clean activities". And that's it, nothing else happens from there.
Do you know what the problem could be? I'm clueless right now...
write
preview
related posts
0 sats \ 2 replies \ @DarthCoin 26 Mar 2023
https://i.postimg.cc/mrvVfD4G/throw-to-bin.gif
reply
0 sats \ 1 reply \ @GUI OP 26 Mar 2023
Helpful!
reply
0 sats \ 0 replies \ @DarthCoin 26 Mar 2023
That was a serious joke. I wrote several guides about nodes and some of them especially for Umbrel. I also wrote the whole troubleshooting manual for Umbrel years ago. https://darthcoin.substack.com/s/english/archive?sort=new https://darthcoin.substack.com/p/umbrel-bitcoin-ln-node https://community.getumbrel.com/t/umbrel-troubleshooting-guide/3632
reply